20A SuperBee ESC BLHELI_S (MUILTSHOT)

Features:
The Latest BLHeli Firmware
Silabs MCU
DLM and Oneshot Capable
Signal wire programmable

BLHeli_S SUPPORTED!  Based off the proven LittleBee design. The SuperBee now has the same Great braking Feeling during Flying ! Now with the Great IC chips and PWM support from the new Utilization of the EFM8BB MCU. Designed to have a massive cooling effect, Supports Damped Light. OneShot125, Oneshot42, and MuiltShot All autodedect out of the box. BLHeli_S ESC with Hardware generated PWM synchronous to MCU yields ultra-quiet motor performance. The _s series is compatible with 2S – 4S LiPo power systems – allowing for clean, voltage-regulated power for the ESC. Twisted-Pair Signal Cable Reduces Interference
The twisted-pair throttle signal cable effectively reduces interference produced in signal transmission and makes the flight much more stable and reliable. The use of new EFM8BB1 MCU, imported MOSFETs  and ceramic capacitors, 3-in-1 drive ICs, 3-ounce copper, 4 layers of PCBs and other quality components guarantees less heat, higher efficiency and rapider response

Super BEE 20A ESC Supporting 2-4S – these ESCs have been the closest performing ESCs to KISS, mosfet driven with fast, dedicated driver chips on quality PCB. This gives you excellent freewheeling and exceptional braking. The next generation in speed controllers! With Silabs processor and gate-drivers which makes the motor braking especially fast. These are OPTO ESCs – this means that you will need your own 5 volt BEC to power your flight controller.  Do not forget a RTF 1V-17V ADJUSTABLE VOLTAGE REGULATOR.    IN STOCK AND READY TO SHIP!

Comes with bootloader enabled. Do not forget a ESC programmer.

Full warranty  for any defective product. Please contact us if you have any problem upon arrival! Fly with confidence!  It is easy to  flash or upgrade the BLHeli firmware via the signal cable (on ESCs), and program 4 ESCs simultaneously after connecting their flight controller to the BLHeliSuite software if the flight controller uses the CleanFlight/BetaFlight firmware. Do not delay, get  more throttle resolution, smoother response, higher RPM ability and automatic detection of OneShot 125, OneShot 42 and Multishot protocols!

BLHeli_S firmware is the next generation code, following the base BLHeli code.
BLHeli_S is designed for superior performance in multirotors,and uses hardware generated motor pwm for smooth throttle response and silent operation.All codes use damped light mode.Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
The code supports features to prevent sync loss. There are tuneable parameters that can make the code run well even inthe most demanding situations, although default settings will work excellently in normal operating environments.
The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multshot (5-25us).
The input signal is automatically detected by the ESC upon power up.