30A Aikon BoltLite ESC BLHELI-(ONESHOT)

Active Braking / Damped Light / Comp_PWM Supported
AutoShot (OneShot125 / FastPWM Auto Detect)
Customized to drive all motors without sync issues or cogging.
To enable new features on Baseflight:
– On Configuration tab, check “Enable OneShot” and “Enable FastPWM”
– Scroll down and click “Save”
To enable new features on Cleanflight:
-On Configuration tab, check the “Enabled” box next to “ONESHOT125” Feature
-Scroll down and click “Save”

This ESC comes with BlHeli bootloader, and flashed with latest BlHeli 14.6 Firmware. In addition to the throttle range is pre-calibrated in the factory so all ESCs start and reach full throttle at the exact same time. These ESCs is pre-programmed and optimized for best performance, and OneShot is included/ready, great for Dampened Light settings. Runs cooler and stronger than LitteBee, yet with almost the same size.

New ESC with F390 MCU for fast processing speed.
Up to 4s- 30A Supported.
This ESC is made of a thicker PCB, multiple capacitors and a switching 3.3v regulator rather than a linear regulator.
Sport to be the most reliable mini-ESC with the Strongest, Smallest, and fastest IC drivers and FETS.
Flashed with BLHeli 14.4 program and is ready for the air.
Runs cooler than Littlebee and put out more thrust.
30AMP with with dedicated drivers and very fast FET switching.
The smallest 30A ESC to date.
This ESC is OPTO, no BEC included.
Enable Racing Mode! (Damped Light Supported)
Settings are changed/tuned for better handing during Racing.
BlHeli 14.4 Firmware.
PWM Frequency/Damped, Motor Timing, Beacon strength/Delay, PPM MIN/MAX Throttle are set to maximum performance. Paired with a Flip32 for automatic detection of all the advantages of Oneshot123.

Features
Active Braking / Damped Light / Comp_PWM Supported
AutoShot (OneShot125 / Fast PWM Auto Detect)
Customized to drive all motors without sync issues or cogging.
To enable new features on Baseflight:
– On Configuration tab, check “Enable OneShot” and “Enable FastPWM”
– Scroll down and click “Save”
To enable new features on Cleanflight:
-On Configuration tab, check the “Enabled” box next to “ONESHOT125” Feature
-Scroll down and click “Save”

Specifications:
BLHeli 14.6 Firmware Installed.
Continuous Current: 30A – high capacity current
Burst Current: 40A
Processor: SiLabs F390 -highspeed refresh rates
Servo Cable Flashable:
Bootloader: BLHeli
Battery: 2S – 4S LiPo
Max Power: 880W
Length: 24mm
Width: 12mm
Weight: 5g