DJI Naza M Lite

The new Naza Lite is the best deal going for the Naza M.  When the new PMU unit was added to the Naza, they decided to release the original Naza M at a greatly reduced price.  In reality it is the sama Naza M we have been using for the past 2 years.  It flies very well, supports GPS, and is very easy to configure.  Altitude hold works flawlessly as does it’s GPS features.  What once cost $399 with GPS (and $230 without), now costs only $209 INCLUDING GPS and a mere $107 without GPS!

The only current limitation of the Naza Lite is that you cannot use products requiring the PMU (Bluetooth adapter and Zenmuse Gimbal).

Click here for Naza M Manual

ALL-IN-ONE DESIGN

ADVANCED ATTITUDE STABILIZE ALGORITHM

The advanced attitude stabilization algorithm not only inherits the outstanding flight stability of DJI products, but also provides excellent maneuverability. It is more flexible and stable, and gives the hobbyists a wonderful flight experience.

MULTIPLE FLIGHT CONTROL MODE/INTELLIGENT SWITCHING

It offers three types of control modes: GPS Atti. Mode (with GPS module), Atti. Mode, Manual Mode. The pilot can switch between the three modes to achieve different flight characteristics. It also can adjust automatically within the flight environment and intelligently switch between GPS Atti. Mode and Atti. Mode to make sure the flight is safe and secure. .

GPS MODULE AVAILABLE/ACCURATE POSITION HOLD

The plug and play GPS module will greatly enhance the performance for Aerial Photography with accurate Position Hold, Return-To-Home and Intelligent Orientation Control functionalities. With the GPS Module, the multi-rotor will have position and altitude locked accurately even in windy conditions. Hovering accuracy is approximately 2.5m horizontal and 0.8m vertical.

 

INTELLIGENT ORIENTATION CONTROL (IOC)

Usually, the forward direction of a flying multi-rotor is the same as the nose direction. By using Intelligent Orientation Control (IOC), wherever the nose points,the forward direction has nothing to do with nose direction:

FAILSAFE MODE

If your transmitter supports failsafe, then you can set failsafe through port-U. Naza controller has built-in auto level failsafe function, which means when the communication between MC and the transmitter is disconnected, the outputs of all command sticks from controller will go to center position. If the GPS module is used, you can also set RTH on failsafe. If your transmitter has only 4 channels, then MC will work in Atti. Mode by default without the failsafe function.

LOW VOLTAGE PROTECTION

In order to prevent your multi-rotor from crashing or other harmful consequences caused by low battery voltage, we have designed two levels of low voltage protection. You can choose not to use this, however we strongly recommend you to enable the protection. Both levels of protection have LED warning as default. The first level will blink the red light continuously; the second level will blink red light continuously and the multi-rotor will descend and land. In manual mode when low voltage protection is triggered the LED warning will be active only.

MOTOR ARM AND MOTOR DIS-ARM

There are four ways to start the motors, see the following picture:

SUPPORT FUTABA S-BUS AND PPM RECEIVER

Minimum Four channel receiver supported, also PPM and Futaba S-Bus receiver supported.

SUPPORTED MULTI-ROTOR TYPES

Naza-M Lite now supports six types of multi-rotor, which meets the different needs of the enthusiasts.

BUILT-IN GIMBAL STABILIZATION FUNCTION

The gimbal stabilization module is compatible with almost all 2-axis gimbal systems. The system will adjust the gimbal and camera according to the attitude of the aircraft after setting the parameters the first time.

REMOTE ADJUSTMENT

The default parameter settings are OK for you to achieve a normal flight, and it also supports remote parameter adjustment by using a control slider on the TX during flight, in order to obtain better performance.