RTF HugESC 12Amp BLHeli-(OneShot)

RTFHugESCs were developed to hug your multicopter frame, maximizing performance, so you can kiss your racing foes goodbye . Featuring ultra light weight construction with excellent thermal properties for an ESC – the MOSFETS are specifically selected to run with the least amount of heat production and highest efficiency.  Users will need to install wires (INCLUDED).

Features
All Nfets (bs_nfet.hex)
12Amp constant with 15Amp burst (In good air flow)
Easy to reach programing pads
Green power LED
NO BEC OPTO!
2 and 3S Capable (no 4S please)
Ultra light weight 1.5g PCB.  couple more grams with all motors and power wires.
400hz and 490hz compatible – DJi, naze32, cc & MultiWii tested with mni motors to 25,000rpm

The RTF 12Amp ESC BL-Heli ships out pre-programmed and optimized for best performance – pre-configured – OneShot is included/ready

Enable Racing Mode! (Dampened Light Supported)

Enable racing mode to change over 10 Settings for maximum performance: : PWM Frequency/Damped, Motor Timing, Beacon strength/Delay,PPM MIN/MAX Throttle are set to maximum performance!  Pair with a Flip32 for automatic detection of all the advantages of Oneshot123

The main advantages of BL-Heli software is the use Active free wheel and active braking (PWM Damping) Dampened Light – 13.1 is OneShot ready for Flip32 – this actively slows the prop/motor down on one side of your Quad, while speeding the prop on the other – without “active-braking” the prop has to slow by inertia and drag alone – this DAMPING Light mode puts the brakes on – the Racing Quad handles better – but you must also increase “P” slowly in 0.1 increments to see the full benefits. Boot-loader enabled! This means all the settings can be changed over the servo cable with a simple pro mini+ftdi combo

These ESC’s have the SimonK Bootloader enabled so they can easily be flashed using the USB Linker/afro linker/Nano linker tools.