RTF Mini “4-in-1” 22-Amp 35×35
Maximize all the performance you can out of your multirotors. Featuring ultra light weight construction with excellent thermal properties for an ESC – the MOSFETS are specifically selected to run SimonK with the least amount of heat production and highest efficiency. Users will need to install wires.
This is not for the timid solderer; there are very small solder pads. Watch your spacer size, the clearance is minimal. 3mm spacers work best, but you still need to file down the thick edges. If you are not comfortable with a soldering iron, please see our B-12A esc.
SimonK firmware installed for best compatibility with high kv motors.
The Simonk AutoShot firmware is pre-calibrated with endpoints 1060us – 1860us. This corresponds to the default endpoints in both Baseflight and Cleanflight. Therefore, “Calibration” procedure is not necessary. Removal of the red wire in the signal cable is ok if you don’t need 5v power out, but both the ground (black) and signal wire (white) need to be connect to the flight controller. Do not connect only the signal wire alone.
- Able to handle Active Braking / Damped Light / Comp_PWM
- AutoShot (OneShot125 / FastPWM Auto Detect)
- Customized to drive all motors without sync issues or cogging.
To enable new features on Baseflight:
– On Configuration tab, check “Enable OneShot” and “Enable FastPWM”
– Scroll down and click “Save”
To enable new features on Cleanflight:
-On Configuration tab, check the “Enabled” box next to “ONESHOT125” Feature
-Scroll down and click “Save”