The Naza is known for being the easiest for beginners to configure, and the simplest to fly. It has a ton of features such as auto landing failsafe, return to home (with GPS), intelligent orientation modes, altitude hold, and more. The new Naza V2 offers additional features below:
NINE TYPES OF MULTI-ROTORS SUPPORTED
Naza-M V2 now supports nine types of multi-rotor, which meets the different needs of the enthusiasts.
Quad I, Quad X;
Hexa I, Hexa V, Hexa Y, Hexa IY;
Octo X, Octo I, Octo V; ( Naza-M V2 does not support the aircraft which has large vibration, so when you choose to use hexa-rotor or octo-rotor, please pay attention to the vibration situation and try to do some vibration dampening);
ENHANCED FAILSAFE MODE
If your transmitter supports failsafe, then you can set failsafe through port-U. Naza controller has built-in auto level failsafe function, which means when the communication between MC and the transmitter is disconnected, the outputs of all command sticks from controller will go to center position. If your transmitter has only 4 channels, then MC will work in Atti. Mode by default without the failsafe function.
INDEPENDENT PMU WITH AMAZING FUNCTION EXTENSION
The Naza PMU V2 has enhanced BEC functionality and provides extendable CAN BUS ports, which can support iOSD, Zenmuse H3-2D gimbal (pitch control). Support is also included for optional Bluetooth LED module to allow parameter adjustment via a mobile APP (future firmware upgrade required for this functionality)
TWO LEVELS OF LOW VOLTAGE PROTECTIONS
In order to prevent crashes caused by low battery voltage, the Naza offers two levels of low voltage protection. While it can be disabled, we strongly recommend using them. All two level protections have LED warning as default. The first level will blink red light low battery warning; the second level of protection is flashing red LED and if in ATTI or GPS mode, the mutirotor will land automatically.
PPM, S-BUS & ORDINARY RECEIVER SUPPORTED
Four channels and more than four-channel receiver supported, also PPM and Futaba S-Bus receiver supported. PPM & S-Bus receivers (the general use of the first 8 channels of S-Bus receiver) to optimize the channel connection, the A, E, T, R, U five-channel function are set in a channel of X2, use only one servo cable to connect the PPM or S-Bus to X2 (for quick and easy installation).
INDEPENDENT LED MODULE
The Independent LED module makes the indication of the flight status and the system status to the ground much clearer. The pilot can get information more quickly and more conveniently, even at night. Real-time flight information is provided through the LED flashing frequency and colour. There is a USB port for configuration.
- Auto Pilot (autolevel)
- Altitude Hold
- Camera Stabalization outputs for Camera Gimbal (Pitch and Tilt)
- Low Voltage Alert (2 levels)
- Autoland at low voltage
- Manual (stunt) mode
- Firmware upgradeable
- PPM and SBUS ports for receviers
- Upgrade ports for future upgrades
- Easy to use configuration software
- Independant LED module
- 9 Types of multirotor motor layout supported.
- Enhanced Failsafe
- Remote Gain Adjustment (from transmitter)
- Supports iOSD, Zenmuse, and optional Bluetooth Connectivity Module