uBlox M8N GPS GLONASS W/ Mounting backplane and Compass

45×45 size, perfect for any standard size board.

These are Pre-configured, Flashed with the correct settings, and tested. To make them Plug and Play.

The NEO-M8N GPS makes evaluating the high performance of the u-blox 8 positioning engine simple. The NEO-M8N board’s user-friendly interface and power supply options make it ideally suited for use in multicopters.

NEO-M8N breakout board features:

•  u-blox M8 engine GPS/QZSS L1 C/A, GLONASS L10F,: WAAS, EGNOS, MSAS Galileo-ready E1B/C (NEO-M8N)
• SuperSense Indoor GPS, -167dBm
• On-board Ultra low noise 3.3V voltage regulator and RF filter for noise blocking
•  I2C (SDA,SCL) and Uart (Tx,Rx)
• Dual band GPS and Glonass antenna
• u-center GPS Evaluation Software
• Extensive visualization and evaluation features
• Supports AssistNow Online and AssistNow Offline A-GPS services
• 1 TTL UART port, 1 I2C port,
• 1 power led; 1 3d lock LED
• Flash memory for firmware upgrade and settings inside in the module (can save setings without battery)
• Battery for HOT module start
• Dimensions: 45x45mm
• Weight  gram
• Fully assembled and ready to use. flashed and tested
• Permanent Configuration Retention
• Cable included

These are Pre-configured, Flashed with the correct settings, and tested. To make them Plug and Play. This is NOT normally done in any other store!

• Super Bright LED
• BlackPlane with Standard Mk style mounting holes 45mm X 45mm
• Blox Neo 6M Chipset
• 38400 bps (Default)  Changed to 115200bps !
• Output GGA, GSA and RMC frames
• 1Hz (Default) Changed to 5Hz!
• Permanent Configuration Retention
• Cable included
• 45x45mm size